Making Your Own Replacement Key For Saab 93 Viggen

saab replacement keys uk owners who lose their keys may be worried about the expense and inconvenience of replacing it. You can save these costs by making your key fob yourself.

To do this, you'll need an flathead screwdriver. Place the screwdriver flat in the slot located at the middle of the case, and then slowly lift it.

Cost

Some used cars have only one key, whereas most SAABs have two keys. In this case the owner has to purchase a new key, and this could be costly. However, there are plenty of ways to save money on this procedure. For instance, if you only require a new key fob case and you want to save money by purchasing an old case from a dealership. However, you should be aware that these cases don't contain the badge or emergency key and are prone to wear out very quickly.

In addition to the cost of a brand new key, you will also need to pay for the installation and programming of the TWICE module. These costs can be expensive and especially if you don't have an extra.

In this regard, it is essential that you always have at least two keys to your car. In this way, if you lose the only key that works you won't end up with no transportation.

The good news is that adding another key to your Saab 9-3 is not as complicated as it might seem. The only issue is that you need to connect the key to the computer in your car. This can be done by an auto dealer, however it may take some time to set up an appointment. You can easily find the necessary information online to aid you with the procedure.

Installation

Most Saab cars manufactured since 1995 feature a unique immobilizer system that makes use of a key-fob for controlling the engine of the car. The system also controls doors' locks as well as the remote functions for the vehicle. It is crucial to keep a spare key on hand to prevent losing the original and causing your car to be stolen. The good news is that if you lose your only working Saab key there are ways to replace it without the need to pay for an expensive dealer service.

First, you need to prepare the new key fob. This can be done by using a flathead screwdriver in order to pry the case open. You just need to insert the screwdriver into an opening in the middle of the case. Then gently work it. If you're having trouble, try using different angles. Once you've opened up the case, remove the electronics and put them in a brand new fob case.

Once you have the replacement fob as well as the key, you are able to begin the process of programming. You'll need to connect your Tech2 and then follow the steps for NG 9-3, either with or without a transponder. It is recommended that you use a replacement TWICE unit that is already connected to the correct key by using a transponder. You can find an equivalent unit on the internet, but you should make sure that the replacement is an OEM part.

Programming

A Tech 2 is required to add a second key to the Removing the electronics and battery from the old key fob is a simple procedure that anyone can complete using a screwdriver with a small flathead. Be careful not to harm any of the small electronic components within the case. It is also recommended to avoid putting liquids on the inside of the case since it could cause damage. It is also recommended to avoid purchasing cloned keys from second-hand sellers, since they may not have been connected to the CIM of your vehicle.