How to Reprogram a Skoda smart key skoda Fob

Many people wonder how to reprogram the car key fob, when they aren't sure what caused it to stop working. This is common, as key fobs can be tossed around and the buttons can break or become jammed.

The first thing you should try is changing the battery. If this doesn't work it could be the time to replace the device.

1. Turn off the ignition

If your key fob has stopped working recently, it is likely that the battery needs be replaced. Batteries are inexpensive and easy to replace. This is the first step you take prior to attempting to reprogram your key.

Make sure the car is turned off and all doors have been shut. Place your current keys in the ignition and turn the switch to "On". It is not recommended to start the engine.

Within five seconds, press the lock button on your key fob. You should hear your car's locks lock and unlock to confirm that you succeeded in entering programming mode. You can now use the key fob both to lock and unlock your vehicle as well as program other remotes. This method can be used to reset an damaged or malfunctioning remote. You might find that this is necessary if the key fob has been dropped, stepped on, or exposed to water.

2. Turn on the ignition.

When you are reprogramming your key fobs, you'll only have a couple of seconds to do it correctly. First, you need to start the ignition. This will reset the computer and give you a fresh start.

Then, shut all your car doors. It is not necessary to open any doors during this procedure as it could cause the programming to be disrupted. Once you have closed all of the doors, insert the key that is the primary one into the ignition and change it to the "On" position.

When the engine starts to turn on, press the lock button on your fob 6 times in 10 seconds. You will hear your car's locks unlocking, indicating that the programming mode was successful. Repeat the procedure for any other remotes you need to program. But, remember that you should program each remote as quickly as the first one, as a delay could result in it failing.

3. Press the Lock Button

The key fob can be used as an extremely small remote that could be used to lock and unlock the car. It also includes a panic button which can be used to call for help in an emergency situation. The key fob may not function for a variety of reasons, such as the battery being damaged or dead.

Follow the steps below to reprogram the key fob if it's not functioning properly. This procedure is applicable to all cars, but it is crucial to follow the exact instructions in your vehicle's manual.

Start the process by turning on the car by inserting the ignition key, but without starting the motor. Press the "unlock" and "panic" buttons on the fob simultaneously for several seconds. You should hear a click, which means the or get in touch with a local locksmith to get help.

6. Press the Lock Button

Updated April 17th, 2023: If your key fob isn't able to unlock doors, it might be time to replace the button cell battery. The tiny silver battery is easy to replace with an screwdriver or fingernail.

Once you have a new battery Follow the steps to program the key fob. Always shut every door, as leaving a door open can cause the process to be disrupted. After you've done this then turn the ignition on to "On" but do not start the engine.

Once the key fob is in programming mode Press the lock button within five seconds. You should hear the sound as the car locks up to confirm the success of the process. Repeat this procedure to program any additional remotes into the car. If the key fob is not working, the problem could be due to a wiring or antenna problem, software problems or a damaged circuit board. It is possible to bring it to a dealer to reprogramme it.