Reasons Your c265 fiat key 500 Key Fob Won't Work

A Fiat key replacement near me 500 key fob allows you to easily open doors and start your car. However, there are numerous reasons why the key fob might stop working. This includes a dead coin-battery and water damage, as well as issues with the receiver module, and interference.

This listing is for an NEW replacement c265 fiat key Flip Key Remote that appears similar to the Ilco brand. It must be professionally programmed (click here to search for local locksmiths for automotive locksmiths). It includes lock, unlock and trunk buttons.

Dead Coin Battery

A dead battery is the most common cause of your 500 key fob that isn't working. Modern key fobs operate with a limited operating range, and should be within some feet of the car to operate. If you are far from your vehicle and press the key fob button the car won't be able to respond, and will display an "Key Fob Not Detected" message in the instrument cluster.

If this occurs you need to replace the battery of your coin-cell (Part Number CR2032) by a new one of a reliable brand, like Panasonic Duracell or Energizer. You can find them at your local hardware store or on the internet.

After you've replaced the battery in the coin cell you can test it by standing close to your fiat car key cutting 500 and pressing the buttons. The car will flash its parking lights, and the key fob should work the lock and unlock switches.

If the fob's key doesn't function after replacing the battery, it might have water damage that prevents it from communicating with the receiver module in your car. Water damage can occur in a variety of ways, from the slightest splash to submerging the fob into salt water at the beach. If you suspect that your fob was exposed to water, you can place it in a rice bag to draw out the moisture. If this doesn't work, your fob will probably need to be reprogrammed by an experienced auto locksmith or the dealer.

Water Damage

Although the fob is equipped with rubber seals to keep water out of the electronic chip inside the device, submerging it into the ocean or washing it in a machine could cause water damage. Saltwater can cause the circuit board to short, and eventually cease to function. It's not a good idea to let the fob get wet however, but don't give it up if you accidentally drop it in water or fail to remove it from your pocket.

First remove the battery from the fob. Clean the electronic chip using isopropyl alcohol or a similar product and dry it completely before replacing the battery. Check the fob to determine if it's functioning. If the key doesn't function, it may need to be changed. This is usually handled by an auto locksmith or dealer.

If the key is newerthe key fob to not receive or transmit the signal. This could occur if the key fob is in proximity to an electronic radio transmitter (cell phones, radar detectors) or any other source of electromagnetic radiation. Other reasons why the key fob may not function include a poor connection to the buttons, damage to the internal chip or water damage.

If the key fob has stopped working one day out of the blue and you've tried everything you can do at home to fix it e.g. You might have a damaged 500 receiver module If you've tried replacing it with a battery, reprogramming, and using an alternative key fob. The receiver module, located beneath the dashboard, detects radio frequency signals from your key fob. Then, it converts them into electronic commands that the vehicle interprets.

Fortunately, there's an easy method of resetting every single system on board in your 500 and include the key fob. Disconnect the battery of 12 volts for about 15 minutes by taking off the negative cable first then the positive cable. Then reconnect the battery. This will clear out any remaining electricity and restart the car's computers. This could help get your key fob working again. If the problem persists you should seek out an expert technician. They can determine the root of your issue.