How to Replace a Nissan Juke Spare Key

Nissan Juke is a fun and stylish hatchback with an unusual engine configuration. It can be a bit noisy, but it's enjoyable to drive.

The battery for the key fob in your nissan key programming software juke needs to be replaced every two years or more, or if the battery is low. You can do it yourself, but you'll need a few tools.

Dead Coin Battery

If your Nissan Juke key fob isn't working the first thing you need to examine is the battery that is inside it. It could be dead and require to be replaced, which is a simple fix that takes just some minutes. Flip the fob upside down and you can access the tiny latch/release located at the back. Remove the old battery and then put in an alternative one, making sure that it is facing down on the fob. Line up the two halves of the fob in a careful manner.

If the fob has been exposed to water, it needs to be cleaned prior to putting the new battery into. It is possible to clean the fob with isopropyl or electronic cleaner and paper towel. Then, let it dry completely prior to installing the battery.

To start the car the key fob has to also be paired to the car. This can be done using the instructions in the owner's guide or an OBDII scan. The most likely reason why the key fob was not working was because it wasn't properly paired. A damaged chip in the fob could cause it to cease to function, but this is rare. In this scenario the need for a new receiver module might be needed. If this is the situation, it will have to be replaced by a skilled technician.

Water Damage

Key fobs operate on batteries and the batteries must be replaced every two years, or as soon as your car ceases to respond when you hit the "start" switch. Keys are fitted with rubber seals to keep water out, but submerging your key fob in a pool or ocean water can damage the chip inside. If this is the situation, you will need to buy a replacement key from Nissan or an automotive locksmith.

If the key fob is equipped with an active chip it's likely that the computer has lost connection to it, which could happen for any number of reasons. A simple restart of the car can fix this, but in the event that the key is showing the "Key ID" error message, you'll need contact Nissan Qashqai Key Replacement or an auto locksmith for assistance.

The three most common reasons for this are dead battery on the key fob as well as a key that is not programmed and a damaged, or malfunctioning key fob that has been damaged or broken. The first two are relatively easy to resolve, while the third one is more difficult to fix immediately, but it can usually be fixed with a bit of perseverance. WhoCanFixMyCar lets you compare Nissan Key Replacement prices in your region and schedule your repair. You can read about the experiences of local Nissan dealerships, Nissan mechanics, and garages in just a few seconds.

Faulty Chip

The key fob of your Nissan Juke has a special chip that transmitn issue with the receiver module within the vehicle. The receiver modules are tuned so they can detect specific frequencies that correspond to signals that are transmitted by nissan qashqai spare key key fobs. If your car has an inoperable receiver module it will not respond to any signal sent by the key fob.

No matter how your Nissan key fob ends up getting damaged, it's always important to have a spare in case the key is broken or lost. A locksmith or a dealership can program the spare key to work with your Nissan. This will allow you to avoid the hassles of losing your keys or locking them in your car.

If your Nissan Juke's key fob has been exposed to rain or clean tap water, you can resolve the issue by cleaning it with isopropyl or an electronic cleaner. If the chip has fried, you'll need to purchase a new keyfob that can be coded for your vehicle by a dealer or locksmith.